موتور-DC-BRUSHLES-STEPPER-SERVO - مجتمع الکترونیک خوارزمی

Supply voltage: 6V-7.4V
Couple: 35kg-cm
60 degrees in 0.20s
-288R

Electromagnetic servo with inner diameter of 7mm
Tie rod electromagnetic steering gear
1: Maximum size 15*17mm [including rocker length]
2: Weight 0.5g
3: Resistance 100 ohms
4: Enameled wire diameter 0.06mm
5: Suitable for 10-20 gram miniature model aircraft
P24-9.1R

Electromagnetic servo with inner diameter of 4mm
1: Maximum size 11*12mm [including rocker length]
2: Weight 0.2g
3: Resistance 100 ohms
4: Enameled wire diameter 0.04mm
5: For 1-5 grams of miniature indoor aircraft, not suitable for other purposes
P24-11R

The electromagnetic rudder weighs 0.42 grams
Internal resistance of about 60 ohms
It is recommended to use 1S lithium battery (3.7V) drive
Attached to the middle magnet is selectively assembled by the user
With pad design, don't worry about disconnecting the cable without installing the airplane, using higher success rate and longer life.
P24-14R

سروو موتور DM-S0090D مخصوص ماشین روبات 9G
-2.7D

سروو موتور DM-S0306D SERVO MOTOR
-5D

سروو موتور DS04-NFC 360
-6D

سروو موتور ES08MA
-3D

سروو موتور HD-1501MG
-12.5D

سروو موتور LW-20MG با گشتاور بالا
-160R

180 درجه
Weight: 13.4g
Dimension: 22.8×12.2×28.5mm
Stall torque: 1.8kg/cm (4.8V); 2.2kg/cm (6.6V)
Operating speed: 0.10sec/60degree (4.8V); 0.08sec/60degree (6.0V)
Operating voltage: 4.8V~ 6.6V
Temperature range: 0℃_ 55℃
Dead band width: 1us
Power Supply: Through External Adapter
servo wire length: 25 cm
-9R

360 درجه
Weight: 13.4g
Dimension: 22.8×12.2×28.5mm
Stall torque: 1.8kg/cm (4.8V); 2.2kg/cm (6.6V)
Operating speed: 0.10sec/60degree (4.8V); 0.08sec/60degree (6.0V)
Operating voltage: 4.8V~ 6.6V
Temperature range: 0℃_ 55℃
Dead band width: 1us
Power Supply: Through External Adapter
servo wire length: 25 cm
-9R

سروو موتور MG945 SERVO MOTOR
-3.3D

سروو موتور MG995
-15R

سروو موتور MG996R
-3.3D

سروو موتور S3003 SERVO MOTOR
-2.25D

سروو موتور SERVO MICRO SG92R
-2D

سروو موتور SG5010 SERVO MOTOR
-2.83D

سروو موتور SG90 SERVO MOTOR
-2.4D

سروو موتور SM-S4306R
-40R

سروو موتور Spring RC SM-S4315R
-10.5D

Electromagnetic rudder weighs 0.18g
Plane size 10x10mm
Internal resistance of about 60 ohms
It is recommended to use 1S lithium battery (3.7V) drive
Attached to the middle magnet is selectively assembled by the user
With pad design, don't worry about disconnecting the cable without installing the airplane, using higher success rate and longer life.
P24-15R

High-speed aircraft model motor double-ring ferromagnetic
peed: 55000 RPM
Output shaft: 0.8 MM
Output shaft length: 7 MM
Lead length: about 46 MM
3.7 V 50000 turn blocking: 1.8 A.
4.2 V 55000 turn blocking: 2 A.
Hollow Cup Specifications: 7 * 16.5 MM
Current: No load: 0.08 A.

DC موتور گیربکسی

DC موتور گیربکسی

DC موتور گیربکسی

DC موتور گیربکسی

Round 020-15110 small motor, small motor shape for the cylindrical shape, the appearance of translucent. For a variety of small technology production.
Voltage: 3v
Shaft diameter: 1.5mm
Appearance: 18 * 17mm
Aperture: 2mm
Hole: about 10mm
Measured: 3V voltage test, no-load current of about 0.08A, stall current of about 0.62A, no-load speed of about 15000 per minute

Gear reduction has a large torque, small noise.
Suitable for electric toys, handicrafts, rotating table box, DC shaking head fans, display, etc.
By changin g the sign of the motor wiring you can change the rotation direction of the motor.
Specifications:
Model: S30K
Voltage: DC12V
Load speed: 14r / min
Output torque: 1.2kg*cm
Output torque: 1.2kg*cm
Material: Metal + Plastic
10R

DC موتور گیربکس
12v-500rpm
-15R

11mm long axis N20 motor micro DC motor motor small motor model motor N20 motor
[voltage]: DC 3V-6V
[Reference current/speed]:
At 3V, no-load current 0.3a, locked-rotor current 1.05a, no-load speed 31000 rpm
When 6V, load current 0.33A, locked rotor current 1.8A, load speed 43,000 rpm
[Size]: thickness 1cm, width 1.2cm, length 1.55cm
[axis length]: 11 mm
[Shaft diameter]: 1 mm
[weight]: about 5.6 grams
-1.8R

Biaxial angle gear motor, worm deceleration, can be directly installed on wheels to make DIY remote control car.
Use case: Fix the gear box with double-sided tape to a small wooden board, small plastic plate (or cardboard), and then install two small wheels with 2.5mm hole diameter on the shaft, then you can make a manual car. Rear wheel system.
Use case: In addition, this can be used to make other technological models that require deceleration power devices, such as mini tanks, pulley drives, and even miniature conveyor belt models.
[voltage]: 3-6V
[Speed]: 3v voltage, speed 700 rev / min, current 90ma; 6v voltage speed 1300 rev / min, current 120ma;
[Size]: 45*22*29mm
[Shaft diameter]: 2.5mm
[Axis length]: The total length is 75mm, the unilateral output shaft is about 28mm

The reduction ratio:1:20 20
the shaft diameter :2 mm
motor voltage 3v and 6v are available
motor speed: when 3V,the reduction is 14500 revolutions, it will be 725 RPM after slow down
The big gear diameter: 26 mm
diameter of axle :2mm



Black box size: 6 cm ;body width: 9 cm (including gear set width)

Specification:
Motor diameter: 23mm
Motor height: 28mm
Shaft diameter: 2mm
Shaft length: 16mm
Operating Voltage: 3-6 VDC

Micro FK130SH Gear Motor Double Shaft With 0.6 Modulus Plastic Worm DC6V 4400RPM
Shaft Diameter: 2mm
Nominal Rated Input Voltage: 3 V, 6 V

Item:Motor&Propeller
Propeller Length:about 138mm
Propeller Aperture:0.8mm(tight)
Motor:0716 Motor(7x16mm), 0720 Motor(7*20mm), 0820 Motor(8x20mm) are available
Voltage:3.7V
Usage:for RC Models

This 130 motor can be used as a hand-cranked generator and wind generator.
[working voltage]: DC 1.5V-12V can be between
[Reference speed]: 3000RPM (6V), 5400RPM (12V)
[Reference current]: 3V voltage, no-load current 30MA, blocking current 90ma
[Motor Size]: Length 25 * Thickness 20 * Height 15mm
[motor shaft diameter]: 2mm
[Out shaft length]: Front end 19mm, rear end 9mm
[motor weight]: about 18.45g

DC موتور گیربکس
6v-500rpm
-15R

BM20A encoder motor 6V encoder motor 1:12 pulse Hall precision micro motor
-45.2R

BM20A encoder motor 6V encoder motor 1:12 pulse Hall precision micro motor
-45.2R

BM20A encoder motor 6V encoder motor 1:12 pulse Hall precision micro motor
-45.2R

Operating voltage: between 6 V and 24 V
Nominal voltage: 12 V
Free-run speed at 12 V: 126 RPM
Free-run current at 12 V: 46 mA
Stall current at 12 V: 1 A
Stall torque at 12 V: 4.2 kg·cm
Gear ratio: 1:34
Reductor size: 21 mm
Weight: 99 g
-47.25R

موتور گیربکس دی سی
GA12-N20-12v-1600rpm
-15R

موتور گیربکس دی سی
GA12-N20-12v-40rpm
-21R

موتور گیربکس دی سی
GA12-N20-3v-1500rpm
-15R

DC موتور گیربکس
3v-500rpm
Slowdown Motor Smart Car
Miniature DC Gear Motor Low Speed ​​Motor

موتور گیربکس دی سی
GA12-N20-3v-50rpm
-21R

موتور گیربکس دی سی
GA12-N20-6v-1500rpm

موتور گیربکس دی سی
GA12-N20-6v-50rpm
-21R

استپر موتور
به همراه ماژول درایور ULN2003

استپر موتور
STEPPER MOTOR
24 ولت
70 اهم

This kind of stepper motor is brand-new, all with original plastic plate, but without the outer box, the workmanship is very delicate and precise, it should be imported, like this kind of microstepping motor, we can not test, please We forgive everyone.
The new two-phase four-wire diameter 6.5mm micro stepper motor, fuselage height 6 MM, work super fine, it should be imported micro stepper motor.
Motor Specifications: 6.5 MM
Motor height: 8 MM
Model: (two-phase four-wire)
Output shaft diameter: 0.8 MM
Output shaft length: 2.5 MM
Weight: 1 g
-40R

Long-axis stepper motor 42BYGH722A 1.8 ° 0.38A-24V
body width 42 mm, 42 mm high, the shaft 31 mm, the shaft diameter of 5 mm, the connection line has 6 lines

موتور براشلس
BRUSHLESS OUTUNNER MOTOR
KV (rpm/v): 1480
Non-load current: 10V/0.1A
-12D