Stepper Motor Driver Board Module ULN2003 for 5V 4-phase 5 line 28BYJ-48 Arduino
 
DESCRIPTION

·       Rated Voltage: DC5V-12V

·       4-phase

·       Reduction Ratio: 1/64

·       Step Torque Angle: 5.625°/64

·       DC Resistance: 200ω±7% (25℃)

·       Insulation Resistance: >10Mω (500V)

·       Insulation Grade: A

·       No-load Pull in Frequency: >600Hz

·       No-load Pull out Frequency: >1000Hz

·       Pull in Torque: >34.3mN.m(120Hz)

·       Detent Torque: >34.3mN.m

·       Temperature Rise: <40K(120Hz)

·       Noise: <40dB (120Hz, No load, 10cm)

·       Board Size: Approx. 40×21 mm

·       On-board XH-5 P socket. Connect 28BYJ-48 Stepper Motor direct

SHORT DESCRIPTION

The ULN2003 stepper motor driver board allows you to easily control the 28BYJ-48 stepper motor from a microcontroller, like the Arduino Uno. One side of the board side has a 5 wire socket where the cable from the stepper motor hooks up and 4 LEDs to indicate which coil is currently powered. The motor cable only goes in one way, which always helps.